Hello ALL,
I believe this to be the correct area for Ignition problems or solutions.
Or should this be placed under Engines?
If not correct then it shall be moved by an Administrator or Moderator, thank you.
I installed the Pertronix Hall Effect parts to my distributor and I've been reading haphazardly about "increased plug gaps can be utilized" with this setup. I also have the 40k volt Flame Thrower Coil which is advertised as a companion option.
Question: How many folk here have this setup and how increased can the gap be?
I'm currently using the factory .035 gap, with aftermarket 8mm "wires".
I've also heard "remove the resistance wire", so w/out an Ohm-meter, which wire is it?
Thank You for ALL replies!!
